How To Install Ac Line Set

This video shows yous how piece of cake the MrCool Universal Quick Connect line set installation actually is.

The two to three ton MrCool Universal serial heat pump split system was designed for easy installation, and the ultimate efficiency for heating and cooling your unabridged home. With a little knowledge, the MrCool Quick Connect line set up installation pick makes it a cakewalk.

Today nosotros're going to evidence you lot only how easy it is to install the MrCool Universal using the pre-charged quick connect line set up.

The two master parts for this system are the outdoor condenser and the indoor air handler.

You will desire to determine where you would similar your condenser, and you will demand to be certain of your dwelling needs.

In this installation, we are setting up the air handler in the horizontal position in the attic, running the line set from the cranium and to the condenser outside.

For this detail installation, nosotros are setting the unit to run as a two-ton instead of a three ton. For this you lot volition need to set the dip switches on both the condenser and the air handler. The settings can exist plant in the installation manual that comes with your arrangement.

For this installation we used the MrCool Pre-Charged Quick Connect line set to connect from the condenser to the indoor air handler.

From the attic we drilled a three and a one-half inch hole for the line set. Depending on the length between the air handler and the line prepare, you may need more than i line set up. In that case you lot volition demand to become the MrCool Universal Quick Connect Line Set Coupler Kit which allows you lot to connect upwardly to 3 line sets together.

The MrCool Universal Coupler Kit screws into the centre connections of the line sets, and nosotros threaded them by paw and tightened them with wrenches.

On the air handler, we unscrewed the flare plumbing fixtures and screwed the quick connect fittings onto the air handler so we could use the pre charged line sets.

We then moved the air handler where it would line up with the existing ductwork.

Then nosotros continued the line set to the outdoor condenser by threading them by paw and then using a wrench to tighten.

Nosotros then used the same method for the indoor air handler.

Then, unscrew the valve covers at the line prepare. You will open the valves using Allen wrenches. For the kickoff valve, we used a five millimeter wrench and twisted left until it stopped. With the side by side valve, we used an eight millimeter wrench. Then we screwed the caps dorsum on.

Since nosotros were already in the cranium, we decided to become ahead and hook up the thermostat wire. The wiring options will depend on your own setup.

Nosotros did the same matter at the outdoor condenser by removing the valve covers and using the Allen wrenches to open the valves.

Once everything was continued, we turned on the power and the unit was prepare to go.

The MrCool Universal is one of the about efficient heat pump air conditioners on the market. and we've created a way to install information technology easily and quickly.

Click here to get your very own MrCool Universal Primal Heat Pump & Ac Organisation

Source: https://iwae.com/resources/videos/mrcool-universal-quick-connect-line-set-installation.html

Share this post